Command and Processes Table - X

For more information on the terms 'Command', 'Process' and 'Macro Command', see Command Table Introduction.

These tables list all commands and processes available in all products. If your product has access to a command or process, the link on the left of the table takes you to a dedicated help file for more information. If no link appears, the function isn't available in your product.

Symbols used in this table:

A green tick indicates that the module is part of the core system licensing for the specified product - no additional module is required.

X A red cross indicates the module is not part of the listed system and any commands held within it cannot be run (a separate product will be required).

� A blue diamond indicates the module is an optional extra for the specified system.

Commands - X

Command Name	Studio RM	Studio OP	Studio EM	Studio UG	Studio Survey	Studio NPVS	Studio Mapper	Description	More Help
x-sections-switch	X	X	X		X	X	X	Turn on or off retaining of drive cross-sectional perimeters.
xsec-string-colour	X	X	X		X	X	X	Set colour for drive cross-section strings in underground design.

Processes - X

Process Name	Studio RM	Studio OP	Studio EM	Studio UG	Studio Survey	Studio NPVS	Studio Mapper	Description	More Help
XRUN								Launch a macro.	Process Help
XVALID			X					The process is designed to assist in the selection of parameters for grade estimation, using the cross-validation method.

For Macro commands, see here.